Table of Contents

    If the app shows an error message when you tap “3. Setup Vehicle Odometer”, please follow these steps to troubleshoot.

    1. Start vehicle engine.
    2. Install “Torque Pro” app. Then open Torque Pro > Realtime Information > long press any empty space > Add display > Digital Display > Distance traveled since codes cleared > choose any size. Make sure Torque shows a number in large font size on that display (not just a dash). You need to purchase Torque Pro if you haven’t yet. You can refund any app within 15 minutes.
    3. If the number is 65535, which means it’s maxed out, so you need to go to “Fault Codes” screen > menu on top right corner > Clear faults on ECU.  It will reset that reading.
    4. Exit Torque completely by tapping the Back button on the phone. It will ask you if you want to exit.
    5. Open TripLog > menu > Settings > OBD Settings > 3. setup vehicle odometer.

    If Torque Pro only shows a dash on the “Distance traveled since codes cleared” display, that means your vehicle does not support that code. TripLog cannot read odometer without that code. You can try a different vehicle.